CONSTRUCTION
The manufacturing process begins with a billet of high-density tungsten.
The billet is then center-ground and shaped. The barrel design gives
you the best of both worlds... A slightly front-weighted dart for
increased accuracy, and a slim barrel for more precise groups. After
all tooling is completed, the barrel is re-checked for proper weight.
COATINGS
Darts are normally coated by painting or baking the barrel surface.
Widows are vapor coated in high heat furnaces that
fuse mixtures of titanium/tantalum nitride and titanium carbide
to the tungsten barrel. These durable coatings, available in black
or gold, provide unsurpassed gripping qualities and a startling
appearance.
STYLES
Ringed or Knurled models.
SPIDER
LEG SHAFTS (Fixed Points)
Four high tensile strength wires are anchored in an aluminum base
and covered with heat shrunk rubber to form a firm hold on the
flight.
ALAMO SHAFT (on the Moveables) < Recommended
LASER
POINTS
A rough black oxide coating is applied to the point to increase
friction and prevent softly thrown darts from falling out.
Black
Alamo shafts used on all MP models. Flights,
shafts, and Case may vary.
|